Are you thinking about building your own fence? Or are you curious about how it is done? Well, here is the step-by-step guide to build a privacy fence that can help you.

Privacy Fence

Most privacy fences are installed about 6 feet tall. It is more common to purchase fencing panels in prefabricated 8-foot sections even though slats can be bought individually.

  • First Step

Start by laying out the locations for end posts and corners. Mark all these spots with some flag or a piece of rebar to enable you in adjusting the locations as needed. Fences are simplest to install on moderately level terrain. But, adjustments could easily be created for minor grades. Carefully, set these end posts and corner. This is because their placement will affect the appearance of the fence. Use a post that is around 8 up to 10 feet high for a 6-foot fence. A square 4-by-4 inch post could be utilized. But, a 6-by-6 inch post is suggested for extra strength.

  • Second Step

Dig at least a 24-inch deep hole. Make sure that diameter is around 3 times larger than the width of the post. It may be required to dig a hole deeper than 25 inches if the location of your fence is subject to high vibration and wind shear, and is unprotected. You might need to pour first a small concrete footer and let it harden before going further in very soft soil. Add the depth of the footer to the depth of your hole.

  • Third Step

Place and secure your post. It is not very stable against wind shear even if you used fill dirt. To secure the post, there are 2 other methods. First is packing the hole with gravel and the second is filling the hole with cement. Using gravel to fill up the hole doesn’t need any curing. Also, it’s much easy to pull out the post whenever it is needed. Gravel will let water to drain. This will avoid wood rot and would also make the fence flexible somehow. This allows the fence to slightly give in the wind.

  • Fourth Step

Between the corner posts, string a line at around 13 inches from the top. At the bottom, you should do the exact same thing. These lines will be utilized in setting your middle posts. In the same manner as the corner posts, dig your holes. You should set the 1st post 8 feet on center, determining from the exterior edge of the corner post. This will make sure that the 8-foot panel section would properly fit. Following middle posts should be all set on 8-foot centers. Remember, posts on 4-foot centers improve strength and stability.

  • Final Step

It is time to install the panels once all the fence posts have been allowed to cure and set. Begin installing the panels by either screwing them or nailing them to the posts starting at the corner post. To assist in holding them, you can place spacers under the panels. This will keep the proper distance from the ground.

Keep in mind that installing a fence would require a lot of your time and effort. Also, you will need to use specialize tools. To make your life a lot easier, you can just call a professional. You easily find one if you click here.